Press and hold the control knob to let the gas flow into the pilot light. Turn the control valve to “on”.
How to turn your water heater pilot light back on.
How to light a pilot light on a gas water heater. If you are using a gas water heater then turn on the gas valve if required. Turn the gas regulator valve to the “pilot” position. Use either a lighter, match or candle to provide the flame required to relight the pilot light.
While holding down the pilot gas valve or the red button with one hand, you will use your other hand to quickly light the pilot.while still holding the gas down, light that pilot.with a lack of combustible air, the pilot light of your water heater is likely to go out. It’s easy to turn your water heater pilot back on. To light this type or water heater, i suggest grabbing a long barbecue lighter.
It is common on fireplaces and older/cheaper furnaces and water heaters. A bad thermocouple will shut off gas to both the pilot and the burner, which is when people notice that the water heater pilot light is out. First, take off the plate that is.
Simply put, if the pilot light goes out, the unit can’t warm up water. Sniff around the pilot light area and make sure you don’t smell any gas. If there’s a leak, then igniting a flame can cause an explosion.
A thermocouple is a function on your water heater that senses the heat on the pilot light and allows gas to flow to the burner. Some water heaters have a separate button for pilot mode, usually a red one, which you’ll press and hold. This will start the flow of gas so you can light the flame.
When the gas burner comes on, use a 50/50 dish soap/water mix to test the screw joints for air bubbles that indicate leaks. Your water heater pilot light works in concert with other parts. Look out for the electrical wiring of the fan.
Usually, the first warning that your pilot light has gone out. If the water heater has a manual “ignite” button, press that to light the pilot. Place this fire source under the orifice of the pilot supply line to ignite the.
While still holding the gas down, light that pilot. The pilot light is a small, continually burning flame that ignites the burner of your gas hot water heater. When relit, the water heater pilot light flame should wrap around the thermocouple bulb.
If that’s clear, you can proceed. There are many reasons why a pilot light could extinguish, and it could be as simple as a temporary interruption or air bubble in the gas line. Once there is a need for heating (or call from a thermostat), a gas control valve releases the gas into the main burner, and the pilot light ignites the gas.
In case there isn’t any, then find out the circuit and make sure if it is on. But first, check for a gas leak. If it doesn’t have the button, or the button fails, press the.
Dial or rotate the gas control knob to the pilot. A pilot light is always burning while using a small amount of gas; Either a water heater is running or not.
The pilot will be a little tricky to reach otherwise. Turn the gas knob to “pilot,” press and hold it down.